Manufactured Home Installation Scope of Work (New Home Setup) 1. Site Preparation Verify site access and delivery path Clear and grade lot as needed Install or verify pad (dirt, gravel, or concrete) Ensure proper drainage and compaction Confirm utility stub-outs are in correct locations Layout home position according to site plan 2. Delivery Coordination Coordinate with manufacturer and transport company Schedule delivery date and time Ensure site is ready to receive home Provide guidance for proper placement on arrival 3. Home Placement Position home on prepared site Align home to approved layout Set home onto blocking system 4. Blocking and Leveling Install piers and footings per HUD and Arizona standards Level home using laser or water level system Shim and secure for structural stability 5. Multi Section Assembly (If Applicable) Align and join sections Install marriage line fasteners Seal roof ridge and exterior seams Ensure structural integrity between sections 6. Anchoring and Tie Downs Install ground anchors or alternative system Secure home with approved tie downs Tension system to meet state requirements Verify wind zone compliance 7. Utility Connections Electrical connection (service hookup) Water and sewer connection Gas connection (if applicable) HVAC system connection and testing 8. Interior Finishing Complete marriage line drywall Tape, texture, and finish seams Install trim, molding, and baseboards Adjust doors, cabinets, and fixtures 9. Exterior Finishing Install skirting around home perimeter Seal all penetrations and seams Install steps, landings, or porches (if included) 10. Final Inspection and Compliance Ensure installation meets: HUD Manufactured Home Installation Standards Arizona Department of Housing (ADOH) requirements Coordinate required inspections Address any corrections if needed 11. Project Completion Final walkthrough with customer Provide documentation and approvals Ensure home is move in ready